Paper
25 September 2023 Distribution network configuration optimization method with large amount of distributed power supply
Xinyang Lu, Xuesong Qi, Li Tian, Shi Liu, Zhenxin Li, Tingyu Liang
Author Affiliations +
Abstract
Due to the randomness and volatility of the distributed power supply, the output of the distributed power supply will change greatly, so that the voltage of each node of the distribution network line may exceed the limit. In order to make all parts of the network meet the prescribed standards and improve the power supply quality of the grid-connected generation system of the distributed power supply, this paper proposes an optimization method of 10kv distribution network configuration connected to the distributed power supply. The optimal access quantity, capacity and grid-connected position of distributed power supply are obtained by taking the minimum network loss and the node voltage not exceeding the limit as optimization objectives. Finally, IEEE33 nodes are used for simulation analysis. After optimization, the active power loss of the system is reduced by 56.87%, and the reactive power loss is reduced by 59.04%, which maximizes the operation mode of the system, greatly reduces the network loss of the system, and improves the economic benefits of the system to a certain extent.
(2023) Published by SPIE. Downloading of the abstract is permitted for personal use only.
Xinyang Lu, Xuesong Qi, Li Tian, Shi Liu, Zhenxin Li, and Tingyu Liang "Distribution network configuration optimization method with large amount of distributed power supply", Proc. SPIE 12788, Second International Conference on Energy, Power, and Electrical Technology (ICEPET 2023), 127882J (25 September 2023); https://doi.org/10.1117/12.3004457
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Power supplies

Control systems

Power grids

Lithium

Design and modelling

Mathematical optimization

Electronic components

Back to Top