Airborne laser swath mapping: results from project laser

William E. Carter; Ramesh L. Shrestha

doi:10.1117/12.327213

8 September 1998 Airborne laser swath mapping: results from project laser

William E. Carter, Ramesh L. Shrestha

Proceedings Volume 3380, Laser Radar Technology and Applications III; (1998) https://doi.org/10.1117/12.327213
Event: Aerospace/Defense Sensing and Controls, 1998, Orlando, FL, United States

Abstract

During October 1996, the University of Florida, the Florida Department of Environmental Protection, the Florida Department of Transportation and the United States Geological Survey-Center for Coastal Geology and Regional Marine Studies jointly conducted a demonstration/test project of airborne laser swath mapping. Project Laser Swath-mapping Evaluation and Resurvey, included mapping of more than three hundred kilometers of beaches, stretching from Mexico Beach, just east of Panama City, Florida, to the western tip of Perdido Key, Alabama. The observations collected along the beaches included returns from the water surface at a number of inlets and from near short portions of the Gulf. The typical flying altitude during the tests was 350 meters above the surface, with an airspeed of 75 meters per second. The laser swatch mapping system operated at 5000 pulses per second, and scanned in a saw tooth pattern with a scan angle of plus and minus 15 degrees and a scan rate of 25 Hz. More than 50 million data points were collected in about three hours of operations, spread over three days. Proprietary computer software was used by the vendor to combine aircraft orientation (roll, pitch and yaw) values from an inertial navigation unit in the laser scanning unit, the angular orientation of the scanner mirror, and the range data to compute vectors from the aircraft to the reflecting surface. These vectors were added to the location of the aircraft, determined by phase difference kinematic Global Positioning System observations to compute the coordinates of the reflecting surface at each measurement epoch, expressed in UTM Northings and Eastings and ellipsoid heights. Commercial software was then used to create a variety of products, including 3D shaded relief `snapshots,' contour maps, false colored maps, cross sections and profiles. Repeat coverage was used to estimate the short term repeatability of the measurements and comparisons with cross sections from classical surveying methods were used to estimate the accuracy of the airborne laser swath mapping results.

Citation Download Citation

William E. Carter and Ramesh L. Shrestha "Airborne laser swath mapping: results from project laser", Proc. SPIE 3380, Laser Radar Technology and Applications III, (8 September 1998); https://doi.org/10.1117/12.327213

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available