Design tools for freeform optics

Garrard, Kenneth; Bruegge, Thomas; Hoffman, Jeff; Dow, Thomas; Sohn, Alex

doi:doi:10.1117/12.617680

My Subscription | My Email Alerts | My Article Collections

BROWSE PROCEEDINGS

Proceedings

BROWSE JOURNALS

Journals

BROWSE SPIE eBOOKS

SPIE eBooks

SUBSCRIPTIONS & PRICING

GENERAL INFORMATION

You are not logged in Logged Out Log In

Proceedings / Volume 5874 / Fabrication and Metrology I

Previous Article | Next Article

Design tools for freeform optics

Proc. SPIE 5874, 58740A (2005); http://dx.doi.org/10.1117/12.617680

Tuesday 2 August 2005

San Diego, CA, USA

Current Developments in Lens Design and Optical Engineering VI

Pantazis Z. Mouroulis, Warren J. Smith, R. Barry Johnson

Alerts
- Alert Me When Cited
- Alert Me When Corrected
Tools
Share
- Email Abstract
- Connotea
- CiteULike
- del.icio.us
- BibSonomy
- Tweet this Article
- Add to Facebook

Abstract

Kenneth Garrard, Thomas Dow, and Alex Sohn

North Carolina State Univ.

Thomas Bruegge and Jeff Hoffman

Optical Research Associates

Freeform Optical surfaces are defined as any non-rotationally symmetric surface or a symmetric surface that is rotated about any axis that is not its axis of symmetry. These surfaces offer added degrees of freedom that can lead to lower wavefront error and smaller system size as compared to rotationally symmetric surfaces. Unfortunately, freeform optics are viewed by many designers as more difficult and expensive to manufacture than rotationally symmetric optical surfaces. For some freeform surfaces this is true, but a designer has little or no feedback to quantify the degree of difficulty for manufacturing a surface. This paper describes a joint effort by Optical Research Associates (ORA) and the Precision Engineering Center (PEC) at North Carolina State University to integrate metrics related to the cost and difficulty of manufacturing a surface into the merit function that is used during the design of an optical system using Code V. By incorporating such information into the merit function, it is possible to balance optical performance and manufacturability early in the design process.

History

Online Aug 23, 2005

Digital Object Identifier

http://dx.doi.org/10.1117/12.617680

Citation

Kenneth Garrard, Thomas Bruegge, Jeff Hoffman, Thomas Dow and Alex Sohn, "Design tools for freeform optics", Proc. SPIE 5874, 58740A (2005); http://dx.doi.org/10.1117/12.617680