Presentation + Paper
18 October 2021 Modeling of grayscale lithography and calibration with experimental data for blazed gratings
Author Affiliations +
Abstract
This paper discusses a collaborative effort of two Fraunhofer institutes to develop a lithography model that simulates the fabrication of blazed gratings using grayscale lithography. The model is calibrated with experimental data of blazed grating profiles. The complete process of modeling and calibration has been performed using the research and development lithography simulator Dr.LiTHO. To emulate the grayscale exposure of blazed gratings in a LED-based micro-image stepper with Dr.LiTHO a thin mask with a linear variation of the mask transmission and corresponding distribution of exposure dose was used. The resulting photoresist profiles are obtained with a standard model for Diazonaphthoquinone (DNQ) photoresists. The calibration of simulated and experimental profile data of blazed gratings is performed using Dr.LiTHO’s inbuilt optimizer - Pythmea. The difference between experimental and simulated profile shapes is expressed by an areaFit. Minimization of this areaFit versus photoresist parameters and correlation analysis help to identify the most appropriate model parameters.
Conference Presentation
© (2021) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Pankaj Bhardwaj, Andreas Erdmann, and Robert Leitel "Modeling of grayscale lithography and calibration with experimental data for blazed gratings", Proc. SPIE 11875, Computational Optics 2021, 118750K (18 October 2021); https://doi.org/10.1117/12.2597203
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Calibration

Photoresist materials

Grayscale lithography

Diffraction gratings

Photomasks

Lithography

Data modeling

Back to Top