Paper
1 September 1990 Development of kinematics for gimballed mirror systems
Author Affiliations +
Abstract
In order to meet the performance contraints imposed on modern stabilization and tracking systems, a wide variety of gimbal and optical configurations are required. As mechanisms become more complex, understanding the kinematic relationships within the assemblies becomes less intuitive. Therefore careful analysis is needed to insure the mechanisms operate properly and to identify appropriate means for control. The analysis should include the development of kinematics for transforming vectors through the gimbal set. Such vectors could be vehicle angular rate, target position, and gravity. This paper outlines the general steps to be followed in such a development and then presents a specific gimballed mirror system to serve as an example for other development of this type. This system uses a strapdown detector and mounts the optics (two front-surface flat mirrors and a derotation prism) on gimbals to stabilize and point the Line-of-Sight. Finally, this system is also used to illustrate the analysis of the kinematics necessary for maintaining the target image upright in the displayed field-of-view.
© (1990) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jim Royalty "Development of kinematics for gimballed mirror systems", Proc. SPIE 1304, Acquisition, Tracking, and Pointing IV, (1 September 1990); https://doi.org/10.1117/12.2322215
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Mirrors

Kinematics

Prisms

Sensors

Control systems

Line of sight stabilization

Control systems design

Back to Top