Silicon micromachined piezoelectric ZnO bimorphs as micromirrors for display applications

Johannes G. Smits; Wai-Shing Choi; M. Edward Motamedi; Angus P. Andrews

doi:10.1117/12.209045

12 May 1995 Silicon micromachined piezoelectric ZnO bimorphs as micromirrors for display applications

Johannes G. Smits, Wai-Shing Choi, M. Edward Motamedi, Angus P. Andrews

Author Affiliations +

Proceedings Volume 2383, Micro-Optics/Micromechanics and Laser Scanning and Shaping; (1995) https://doi.org/10.1117/12.209045
Event: Photonics West '95, 1995, San Jose, CA, United States

Abstract

Cantilever beams of piezoelectric heterogeneous bimorphs (ZnO-on-Si₃N₄ bimorphs) have been designed and fabricated on silicon wafers for applications as micro-mirrors. The bimorph is a composite beam comprised of a bottom layer of Si₃N₄ and a top layer of ZnO which has been metallized with Au/Cr film on both surfaces. A metallized rectangular pad near the tip of the bimorph has been designed to serve as a deflecting micro-mirror. The fabrication procedures of the bimorphs using surface-machining method with ZnO as the sacrificial layers are presented in the paper. Measurement of the deflection of the bimorph as a function of dc voltages showed two different regimes of voltage dependence. For voltage magnitude less than 1 volt, small and linear deflection was obtained which was consistent with the theoretical prediction. At voltage magnitude larger than 1 volt, large deflection was obtained with quadratic dependence on the magnitude of the applied voltage. The large deflection can be attributed to joule heating effect due to current conduction in the semiconducting ZnO. The fundamental resonance frequency of the bimorph has been measured and is in close agreement with the predicted value obtained from the Euler-Bernoulli beam equation. Because of the quadratic dependence on the voltage, resonance can be obtained even though the frequency of the driving signal was only at half of the true resonance frequency. Air damping was observed which led to a reduction of the Q-factor. To test the bimorph for micro-mirror display applications, a HE-Ne laser beam has been directed at a metallized pad at the tip of the bimorph. A sinusoidal signal superimposed with a dc bias has been applied to the bimorph. The scanning range of the reflected laser beam is reported and discussed in the presentation.

Citation Download Citation

Johannes G. Smits, Wai-Shing Choi, M. Edward Motamedi, and Angus P. Andrews "Silicon micromachined piezoelectric ZnO bimorphs as micromirrors for display applications", Proc. SPIE 2383, Micro-Optics/Micromechanics and Laser Scanning and Shaping, (12 May 1995); https://doi.org/10.1117/12.209045

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE