Flip-chip packaging for smart MEMS

Felix Mayer; Gerald Ofner; Andreas Koll; Oliver Paul; Henry Baltes

doi:10.1117/12.320169

20 July 1998 Flip-chip packaging for smart MEMS

Felix Mayer, Gerald Ofner, Andreas Koll, Oliver Paul, Henry Baltes

Proceedings Volume 3328, Smart Structures and Materials 1998: Smart Electronics and MEMS; (1998) https://doi.org/10.1117/12.320169
Event: 5th Annual International Symposium on Smart Structures and Materials, 1998, San Diego, CA, United States

Abstract

The cointegration of IC microsensors, actuators and readout circuit leads to smart Micro Electro Mechanical Systems (MEMS) which are superior in many aspects to their conventional discrete counterparts. However, the packaging of such device is still a challenge and a major factor of the overall production cost. On one hand MEMS need protection against mechanical contact and media. On the other hand, the encapsulation of the transducer must be partially permeable to the environment. We developed a packaging method which successfully addresses these challenges. Thereby the number of steps needed to electrically contact and partially seal the MEMS are reduced by combining them using flip-chip technology. An opening in the substrate is aligned with the transducer, and enables the interaction with external media. Concurrently with the electrical connections, a frame plated onto the microsystem is soldered to a corresponding structure on the substrate. This frame seals the rest of the chip from the medium interacting with the transducer. Using passive test chips we evaluate the performance of the new packaging method. Various underbump metal and solder deposition techniques were investigated. Both ceramic and flexible organic substrate materials were used. The combination Ni/Au bumps/InPb₄₀ solder/ceramic substrate showed the following mechanical and electrical parameters: For 98% of the tested chips, the helium leakage rate of the sealing frame surrounding the sensor is below the threshold of the used mass spectrometer (5 X 10^-7 Pa l s^-1). For flip-chip pads ranging from 200 to 300 mm square, the bump resistances are smaller than 2 m(Omega) . The approach, is illustrated with three successfully packaged MEMS for the measurement of humidity, gas flow, and volatile organic compounds, respectively. They all contain integrated readout circuitry providing digital output.

Citation Download Citation

Felix Mayer, Gerald Ofner, Andreas Koll, Oliver Paul, and Henry Baltes "Flip-chip packaging for smart MEMS", Proc. SPIE 3328, Smart Structures and Materials 1998: Smart Electronics and MEMS, (20 July 1998); https://doi.org/10.1117/12.320169

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available