Paper
29 April 2003 Fabrication of smooth thin diamond-like carbon microstructures by photolithography together with dry and wet etching techniques
Liujiang Yu, BengKong Tay, Divakaran Sheeja
Author Affiliations +
Proceedings Volume 5118, Nanotechnology; (2003) https://doi.org/10.1117/12.498877
Event: Microtechnologies for the New Millennium 2003, 2003, Maspalomas, Gran Canaria, Canary Islands, Spain
Abstract
Diamond-like carbon (DLC) films produced by the filtered cathodic vacuum arc (FCVA) technique have attracted considerable interest over the last few years, due to their excellent mechanical, electronic, optical and tribological properties in addition to the smooth surface morphology. However the utilization of DLC films in MEMS application has so far been limited due to the high compressive stress induced during growth. The large intrinsic compressive stress in the films causes the structure to curl up. By making use of substrate pulse bias of 1kV, the stress in the film has been lowered to 1.3GPa. Thin (~150nm) diamond-like carbon cantilever microstructures were fabricated in this film by photolithography together with dry (reactive ion etching (RIE)) and anisotropic wet etching techniques. The problems associated with lithography, etching and processing of the microstructures are discussed in detail, in addition to the characterization of the films such as stress, surface morphology and microstructure.
© (2003) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Liujiang Yu, BengKong Tay, and Divakaran Sheeja "Fabrication of smooth thin diamond-like carbon microstructures by photolithography together with dry and wet etching techniques", Proc. SPIE 5118, Nanotechnology, (29 April 2003); https://doi.org/10.1117/12.498877
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Carbon

Raman spectroscopy

Optical lithography

Silicon

Wet etching

Etching

Fabrication

Back to Top