Paper
19 March 2007 Photon counting pixel architecture for x-ray and gamma-ray imaging applications
Author Affiliations +
Abstract
Photon counting is emerging as an alternative detection technique to conventional photon integration. In photon counting systems, the value of each image pixel is equal to the number of photons that are absorbed by the radiation detector. The proposed pixel architecture provides a method for energy windowing and serial readout for low-dose gamma-ray imaging. Each pixel is comprised of a radiation detector and integrated analog and digital circuitry. A prototype was developed on a printed circuit board (PCB) using discrete electronic components. In this research, we present the experimental results for the operation of the photon counting pixel with energy windowing and investigate the compromise between pixel noise level and photon count rate.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Amir H. Goldan, Li Ng, J. A. Rowlands, and Karim S. Karim "Photon counting pixel architecture for x-ray and gamma-ray imaging applications", Proc. SPIE 6510, Medical Imaging 2007: Physics of Medical Imaging, 65103V (19 March 2007); https://doi.org/10.1117/12.710358
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Photon counting

Sensors

X-rays

PIN photodiodes

Amplifiers

Silicon

Analog electronics

RELATED CONTENT

The AGIPD System for the European XFEL
Proceedings of SPIE (May 03 2013)
Imaging by photon counting with 256x256 pixel matrix
Proceedings of SPIE (September 29 2004)
Astro-E hard x-ray detector
Proceedings of SPIE (October 18 1996)

Back to Top