Paper
10 May 2007 Low power considerations and design for CMOS VCOs applied for direct conversion receivers at 5GHz
Iñigo Adin, Carlos Quemada, Hector Solar, Beatriz Sedano, Iñigo Gutierrez
Author Affiliations +
Proceedings Volume 6590, VLSI Circuits and Systems III; 659019 (2007) https://doi.org/10.1117/12.721661
Event: Microtechnologies for the New Millennium, 2007, Maspalomas, Gran Canaria, Spain
Abstract
Low power design often requires direct conversion architectures, such as low-IF or zero-IF. Any of these two possibilities needs a low power, low phase noise voltage control oscillator (VCO) in the frequency synthesizer. This work is focused on low power considerations applied to the practical modern conception of this device. Fulfilling the standard specifications (output power, phase noise, frequency range) should be completed with this deeper step. A conscious design leads moreover to an improvement in the results obtained by the classical considerations. The increase of the quality factor of the passive elements is one of the key points, followed by an accurate design of the architecture scheme. Furthermore, lower current consumption provides higher oscillation frequencies and facilitates higher frequency ranges, which follow the trends of modern wireless and wideband communication standards. In order to validate the aforementioned assumptions, a CMOS VCO has been implemented in UMC 0.18μm 1P6M technology, with power consumption down to 3.4mW.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Iñigo Adin, Carlos Quemada, Hector Solar, Beatriz Sedano, and Iñigo Gutierrez "Low power considerations and design for CMOS VCOs applied for direct conversion receivers at 5GHz", Proc. SPIE 6590, VLSI Circuits and Systems III, 659019 (10 May 2007); https://doi.org/10.1117/12.721661
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Standards development

Oscillators

Phase shift keying

Transistors

Passive elements

Telecommunications

Homodyne detection

Back to Top