A new control system was designed and built within the project to implement an active surface at the LMT. The technical concept for the active surface control system is to provide a set of bus boxes with built-in control and I/O capabilities to run four actuators each. Bus boxes read the LVDT sensor position and limit switch status for each actuator and use this information to drive the actuator’s DC motor, closing the position loop. Each bus box contains a DC power supply for the electronics, a second DC power supply for the motors, an embedded controller with I/O to close the position loop, and a custom printed circuit board to condition the LVDT signals and drive the motors. An interface printed circuit board resides in each actuator providing a single connector access to the LVDT, the motor, and the limit switches. During the fall of 2013, 84 bus boxes were commissioned to control the 336 actuators of the inner three rings of the telescope. The surface correction model was determined using holography measurements and the active surface system has been in regular use during the scientific observation at the LMT. |
ACCESS THE FULL ARTICLE
No SPIE Account? Create one
CITATIONS
Cited by 2 scholarly publications.
Actuators
Control systems
Telescopes
Electronics
Power supplies
Connectors
Switches