20 May 2021 Aspherical lens design for real light-emitting diode with flux compensation through angular flux mapping
Author Affiliations +
Abstract

A design scheme for an aspherical lens including two step processes is proposed and demonstrated to direct appropriate flux to the expected target illumination. The first-step design is based on a point source and the surface geometry is determined. The flux deviation between the design and target illumination becomes the factor in the optimization process, and the angular flux compensation is done to adjust the light pattern. Finally, the experimental result shows that high similarity between the target and the measurement is observed and full width at half maximum angle error is within 3%, which are both better than those in the aspherical lens design based a point source and a real light-emitting diode without optimization by flux compensation.

© 2021 Society of Photo-Optical Instrumentation Engineers (SPIE) 0091-3286/2021/$28.00 © 2021 SPIE
Kuo-Hao Liao, Ching-Cherng Sun, Chi Shou Wu, Shih-Kang Lin, Tsung-Hsun Yang, and Yeh-Wei Yu "Aspherical lens design for real light-emitting diode with flux compensation through angular flux mapping," Optical Engineering 60(9), 091505 (20 May 2021). https://doi.org/10.1117/1.OE.60.9.091505
Received: 16 November 2020; Accepted: 3 May 2021; Published: 20 May 2021
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Aspheric lenses

Light emitting diodes

Lens design

Light sources

Optical engineering

Illumination engineering

Monte Carlo methods

Back to Top