The bandgap of indium nitride has long been accepted to be 1.9 eV. However, recent results have cast doubt over this as modern epitaxy techniques have allowed experimental studies of high quality material. Single crystalline and polycrystalline indium nitride films have been grown on (0001) sapphire and silica glass using plasma assisted molecular beam epitaxy (PAMBE). Optical measurements on the films revealed a luminescence feature in the vicinity of 0.8 eV for all films, both on sapphire and glass. No feature around 1.9 eV could be identified above the background noise. To our knowledge this is the first report of polycrystalline InN exhibiting the 0.8 eV feature. Ion beam analysis of the material could find no measurable oxygen contamination in the bulk of the films. These results along with recent reports of blue shifting of the absorption onset of InN films with increasing oxygen content appear to point towards oxygen contamination as being the source of the previously reported higher bandgap. Like other groups we observed a small anomalous blue shifting of the luminescence with increasing temperature when using a germanium detector. We have verified that this is a real feature by measuring the temperature dependent PL with a lead sulphide detector. Two distinct growth regimes were identified. High In:N flux ratios lead to spotty RHEED accompanied by a morphology of flat plateaus separated by narrow valleys. Low In:N flux ratios lead to rough films consisting of facets largely disjoint from each other. Surprisingly, this regime gave streaky RHEED, suggesting high levels of crystal alignment between facets and high crystal quality within facets.
A wide variety of thin layer coatings have been reported for inhibiting the occurrence of post-release stiction in MEMS. Hydrophobic coatings such as self-assembled monolayers perform this function very well, but have a limited lifetime due to eventual generation of wear-induced damage. On the other hand, metallic oxides with superior wear resistance are hydrophilic in character, making them prone to stiction in humid environments. This paper describes the investigation of several dielectric materials as potential candidates for hydrophobic coatings with good wear resistant properties. Films were grown using a combination of vacuum deposition techniques, including enhanced variations of pulsed laser deposition. Contact angle and hardness measurements were performed on flat single crystal wafers for evaluation of film properties, and initial trials on a lateral friction test structure developed at Sandia National Laboratories were performed.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.